Hydraway 300 - Physical Properties
| Product | Test Method | Typical Value |
|---|---|---|
| Compressive Strength | ASTM D-695/16211 | 19,000 PSF |
| Flow Rate At 1,500 PSF | ASTM D-4716 2 | 27 GPM/FT-Width |
| Peel Strength | ASTM D-1876 | 35 lbs/FT-Width |
| Fabric (4.5 oz.) | ||
| Grab Tensile Strength | ASTM D-4632 | 120 lbs. |
| Grab Elongation | ASTM D-4632 | 50% |
| Puncture Strength | ASTM D-4833 | 65 lbs. |
| Mullen Burst | ASTM D-3786 | 225 psi |
| Trapezoidal Tear | ASTM D-4533 | 50 lbs. |
| Wide Width Tensile | ASTM D-4595 | 50 lbs/in |
| UV Resistance | ASTM D-4355 | 70% |
| Apparent Opening Size (AOS) | ASTM D-4751 | 70 US Std. Sieve |
| Permittivity | ASTM D-4491 3 | 1.8sec. |
| Permeability | ASTM D-4491 4 | 0.21 cm/sec |
| Water Flow Rate | ASTM D-4491 | 135 gpm/ft 4 |
| Roll Dimensions | ||
| Width | 38" | |
| Length | Up to 550' | |
| Footnotes | ||
| 1. Modified - an existing ASTM test was modified since a recognized test method had not been established for this type of product at time of testing. | ||
| 2. Gradient of 0.1 | ||
| 3. Fabric to core. | ||
| 3. The property values listed below are effective 1/2/01 are subject to change without notice. | ||
| 4. Values shown are in weaker principal direction. Minimum average roll values are calculated as the typical minus two standard deviations. Statistically, it yields a 97.7% degree of confidence that any samples taken from quality assurance testing will exceed the value reported. | ||
| View Spec Data from First Source | ||